2026 RAM 1500 Ramcharger Alignment in Albuquerque, NM

About 60 minutes is typical for a full four-wheel alignment.

That estimate covers lift, inspection, measurements, adjustments to factory specs, and a short road test at Larry H. Miller Chrysler Jeep Dodge Ram Albuquerque in Albuquerque. Electric drivetrains and RWD geometry on the 2026 Ram 1500 Ramcharger do not change the basic alignment workflow, but technicians account for vehicle weight distribution and suspension calibration during the service.

• Initial suspension and tire inspection on the lift
• Measured caster, camber, and toe with OEM-grade equipment
• Verify adjustments with a road test and before/after printout

General guidance is every 2–3 years or about 30,000 miles, and after suspension work or major impact events.

Those intervals are practical for typical driving; local road conditions in Albuquerque—potholes, construction, and canyon surfaces—can accelerate the need for alignment. If you drive frequently on rough roads or notice handling changes, bring the 2026 Ram 1500 Ramcharger in sooner for a check at Larry H. Miller Chrysler Jeep Dodge Ram Albuquerque.

• Check alignment after hitting a large pothole or curb
• Schedule alignment after replacing suspension components
• Confirm alignment when you see uneven tire wear

Common signs include uneven tire wear, the truck pulling to one side, an off-center steering wheel, or vibration at speed.

Those symptoms often indicate misaligned caster, camber, or toe and can appear on the 2026 Ram 1500 Ramcharger after impact or wear. If you notice any of these while driving around Albuquerque, schedule a diagnostic alignment at Larry H. Miller Chrysler Jeep Dodge Ram Albuquerque to prevent accelerated tire wear and to restore proper steering response.

• Uneven tread wear across the tire shoulder
• Vehicle drifts left or right when driving straight
• Steering wheel not centered at straight-ahead

A standard four-wheel alignment includes inspection and adjustment of caster, camber, and toe to factory specifications with a before-and-after printout.

The service typically begins with a lift inspection of suspension components and tires, followed by wheel measurements using calibrated alignment equipment. Technicians make adjustments to bring caster, camber, and toe back to OEM tolerance and finish with a road test to confirm stable steering and handling for the 2026 Ram 1500 Ramcharger.

• Suspension, tie-rod, and steering inspection
• Measured caster, camber, and toe; adjustments to factory spec
• Before-and-after printout and a verification road test

If worn tie rods, ball joints, or struts are present, alignment alone may not hold and additional repairs are required.

Technicians at Larry H. Miller Chrysler Jeep Dodge Ram Albuquerque start with a suspension inspection to detect wear that prevents alignment corrections from lasting. If components are loose, bent, or worn, certified service staff will explain the required repairs before re-aligning so the adjustment remains within factory tolerances.

• Inspection flags worn steering or suspension parts first
• Repairs are recommended before final alignment if needed
• Alignment verified after parts replacement to OEM specs

Not always—if the truck tracks straight and shows no wear or symptoms, alignment can usually wait until scheduled intervals or after suspension work.

However, subtle drift or uneven wear that isn’t obvious at low speeds can still reduce tire life and efficiency for the 2026 Ram 1500 Ramcharger. If you drive on Albuquerque roads with frequent construction or potholes, a proactive alignment check can confirm geometry is within factory tolerance and protect tire investment.

• Reasonable to skip alignment if no symptoms and recent check
• Schedule a check after shocks, springs, or steering work
• Use alignment to document factory-spec settings for resale or warranty records

This four-wheel alignment follows a clear, step-by-step process tailored to factory geometry. The service begins with a vehicle-on-lift inspection of tires, tie rods, ball joints, and steering components to identify anything that would prevent a stable alignment. Technicians then measure caster, camber, and toe with calibrated alignment equipment and adjust each axis to the manufacturer's specified tolerances. After adjustments, a before-and-after printout documents the changes for your records. Finally, the vehicle receives a short road test to confirm handling, steering centering, and that the 2026 Ram 1500 Ramcharger tracks correctly.

Throughout the process, certified technicians log measurements and recommend repairs if suspension wear is found. For service specials, check service specials. To book the alignment, schedule service.

Larry H. Miller Chrysler Jeep Dodge Ram Albuquerque provides alignment services for drivers in Albuquerque and nearby communities. Local roads, seasonal construction, and occasional potholes can impact wheel alignment, so the dealership’s service center focuses on restoring factory geometry to support safe handling. The service center works with OEM-grade alignment machines and follows published adjustments for caster, camber, and toe. If your vehicle shows pulling, uneven tire wear, or an off-center steering wheel, bring it in for a diagnostic alignment and documented adjustments.

Schedule a visit at the dealership service department online or call the service desk. Directions and appointment booking are available—schedule service for a factory-spec alignment.

Factory alignment work focuses on the three primary settings: caster, camber, and toe. Technicians use OEM-level alignment equipment to measure and correct these angles at the front and rear as specified by the manufacturer. The process ensures the steering geometry is returned to factory tolerances and helps prevent accelerated tire wear and poor handling. Common issue callouts for modern crew cab pickups can include toe changes after minor impacts and camber shifts from bent control arms; technicians inspect components before making adjustments.

Bring your 2026 Ram 1500 Ramcharger to Larry H. Miller Chrysler Jeep Dodge Ram Albuquerque in Albuquerque for a factory-spec alignment — schedule service.